Seiko Club Singapore Museum

Recommended place for toolss

jaded
Recommended place for toolss
Hi all, all this while i have been using a 0.8mm flat head screw driver to adjust some of my watch bracelet and changing of watch strap. however sometimes i feel that 0.8mm is still not small enough as sometimes i feel abit of the screw driver 'cow tio' the side of the hole when i put the screw driver in.



any recommended size or recommendation for me to get for tool to adjust the bracelet and changing of strap?



Also looking for brush to like clean up the watches (like clean up the crown when unscrewed). again, any recommendation?



tks all in advance!
fireal
Re: Recommended place for toolss
use a toothbrush if u want to scrub it



if just to brush off some dust , use a blower brush





screw driver , if u want something simple just go daiso , they have precision screw sets

if u want something better quality then u can go to khatena to get bergeon tools
jaded
Re: Recommended place for toolss
alright, shall check out daiso. should suit me! cheap and good!



i should avoid brushing with water if im using toothbrush to brush the crown when in the 'unscrewed' position right? if not water may get in and all?

or am i thinking too much?
fireal
Re: Recommended place for toolss
yup dont use water with the crown unscrewed moisture can get in and youll get foggy crystal and movement rust and all that later on